C221NA Series - 1080p HD Wired Bullet Camera: Installation Guide

This article gives installation instructions for your C221NA 1080p HD Wired Bullet Camera.

What is included:

• 1080p HD Wired Bullet Camera
• BNC/DC Cable
• 12V/1A Power Adapter
• Mounting Hardware

DVR Connection

Before installing, ensure the camera is ready to capture footage by connecting it to your DVR's video input with the BNC/DC cable.

Camera Placement Tips:

• Consider what you want to monitor and find the best area for coverage.
• Place the camera close to the area of interest.
• Avoid placing the camera directly in front of obstructions like trees, bricks, rain gutters, or reflective surfaces.
• Install the camera where it is difficult for thieves and vandals to reach.
• Ensure the mounting surface can support at least 3 the camera's weight.
• The ideal position is about 10 ft/3 m above ground, angled 15° downward.
• Secure the cables so they cannot be seen or easily cut.

Installation:

Warning: Ensure the mounting surface supports 1.65 lbs (0.72 kg), 3 the camera's weight.

1. Use the mounting template to mark and drill holes for screws and the camera's cable.

Note: To route cables along a wall, use the camera's cable notch.

2. Insert anchors for surfaces like drywall, wood, brick, masonry, or concrete

3. Guide the camera's cable through the surface opening or cable notch.
4. Connect one end of the BNC cable to the camera's video output and the other end to the DVR's video input. Then, plug the camera's power adapter into its port and connect it to a power outlet to turn on the camera.

5. Attach the camera's bracket to the surface using the provided screws and a screwdriver.

6. Loosen the adjustment screws with a screwdriver to position the camera, then securely tighten it in place.

7. Important! Remove the vinyl film from the camera lens for a clear view.