This article gives installation instructions for your LNB45ABB and LNB45ABW 4MP IP PoE Wired Bullet Cameras.
What is included:
- 4MP IP PoE Wired Bullet Camera
- Mounting Template
- Anchors & Screws (4)
- Weather-resistant Cap
Camera Placement Tips:
- Consider what you want to monitor and find the best area for coverage.
- Place the camera close to the area of interest.
- Avoid placing the camera directly in front of obstructions like trees, bricks, rain gutters, or reflective surfaces.
- Install the camera where it is difficult for thieves and vandals to reach.
- Ensure the mounting surface can support at least 1.5 lbs/0.6 kg (3 the camera's weight).
- The ideal position is about 10 feet/3 meters above ground, angled 15° downward.
- Secure the cables so they cannot be seen or easily cut.
Installation:
Warning: Ensure the mounting surface supports 3.18 lbs/1.4 kg, 3 the camera's weight.
- Use the mounting template to mark and drill holes for screws and the camera's cable.
Note: To route cables along a wall, use the camera's cable notch.
- Insert anchors for surfaces like drywall, wood, brick, masonry, or concrete.
- Guide the camera's cable through the surface opening or cable notch.
- Connect one end of the Ethernet cable into the camera's Ethernet connector and the other end into the NVR's PoE port.
- Secure the weather-resistant cap by twisting it onto the camera's Ethernet connector. If exposed to rain, seal it with silicone or electrical tape.
- Attach the camera's bracket to the surface using the provided screws and a screwdriver.
- Loosen the adjustment screw with a screwdriver to position the camera, then securely tighten it in place.
- Important: Remove the vinyl film from the camera lens for a clear view.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article