E842CA, E842CD, A Series, A14 - 4K IP Wired Bullet & Dome Security Cameras: Installation

Modified on Fri, Mar 21 at 3:37 PM

This article provides instructions for installing your 4K IP Wired Bullet Security Camera E842CA, E842CD Series.

Table of Contents:


What's Included

  • 4K Ultra HD Bullet Camera or 4K Ultra HD Dome Camera
  • Ethernet Extension Cable
  • Mounting Template
  • Anchors & Screws (4)
  • Mounting Bracket (included with dome cameras only)

Camera Placement Tips

  • Take into consideration what you want to monitor and where is the best coverage area.
  • Place your camera close to the area of interest.
  • Point the camera where there is the least amount of obstructions (i.e. tree branches)
  • Install the camera in a location that is difficult for thieves and vandals to reach.
  • The best position is 10 ft (3 m) above ground, angled 15° down.
  • Secure cabling so that it is not exposed or easily cut.

Installation

Camera Mounting

E842CB - Bullet Camera

  1. Use the mounting template to mark and drill screw holes. If mounting on drywall or other soft surfaces, insert

    the included drywall anchors.

  2. If running the cable through the wall, feed it through the pre-drilled hole. If running it along the wall, use the

    round cable notch on the camera cover.

  3. Loosen the adjustment screw and position your camera as needed, then tighten to secure it in place.

  4. Peel off the protective film from the camera lens.

  5. Follow the next section for proper cable connections.

E842CD - Dome Camera

E842CD dome camera installation

  1. Use the mounting template to mark and drill screw holes. If mounting on drywall or other soft surfaces, insert

    the included drywall anchors.

  2. Attach the bracket to the surface using a Phillips-head screwdriver and the included screws, ensuring the

    PUSH / FRONT tab faces upward.

  3. If running the cable through the wall, feed it through the pre-drilled hole. If running it along the wall, use the

    round cable notch on the camera cover.

  4. Move the dome camera and cover to your preferred angle. Adjustments after mounting will be difficult due to

    potential cable obstructions.

  5. Align the square notch on the camera cover with the PUSH / FRONT tab on the bracket, then slide the camera

    downward until it clicks into place.

  6. Tighten the lock screw with a Phillips-head screwdriver to lock it. To remove later, loosen the screw, press

    the tab, and push upwards.

  7. Minor camera angle adjustments may be possible but are limited by cable positioning.

  8. Peel off the protective film from the camera lens.

  9. Follow the next section for proper cable connections.



Camera Connection

Connect your camera directly to your recorder using the camera's Ethernet extension cable.

Weather-Resistant Cap

Twist the Ethernet extension cable's pre-attached weather-resistant cap securely onto your camera's Ethernet connector. If exposed to regular precipitation, seal the cap with silicone and electrical tape.

E871ABImage4.jpg



Was this article helpful?

That’s Great!

Thank you for your feedback

Sorry! We couldn't be helpful

Thank you for your feedback

Let us know how can we improve this article!

Select at least one of the reasons
CAPTCHA verification is required.

Feedback sent

We appreciate your effort and will try to fix the article

Search for more topics

Still have questions?

If you still have questions or couldn’t find what you’re looking for, our support team is here to help—feel free to reach out for further assistance.

Contact Us