LNZ81P25, PTZ Series, P25 - 4K IP Wired Camera with 25x Zoom and IK10 Vandal-Proof Rating: Setting Presets

The following article provides instructions on how to set presets on your Pan-Tilt-Zoom Camera from the NVR.

For information on using your PTZ controls, see the article Controlling Your 4K Ultra HD IP Pan-Tilt-Zoom Camera.

TABLE OF CONTENTS

• Presets
• Tours
• Patterns
• AutoScan

Presets

Presets will save a camera position for quick retrieval.

To add preset locations:

1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then click Pan/Tilt/Zoom.
2. The PTZ controls open. Click to open advanced PTZ controls, then click .
3. Click the Preset tab.
4. Enter the number of the preset you want to create under Preset.
5. Move the camera to the desired position and click Set.

To go to a preset location: * Under No., select the number of the preset you want to go to, then click .

Tours

Tours will cycle through a set of presets.

To add tours: 

1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then click Pan/Tilt/Zoom.
2. The PTZ controls open. Click to open advanced PTZ controls, then click .
3. Click the Tour tab.
4. Under Patrol No., enter the number of the tour you want to create.
5. Under Preset, select a preset you want to add to the tour.
6. Click Add Preset.
7. Repeat steps 5 & 6 to add additional presets to the tour.

To run a tour: * Under No., select the number of the tour you want to go to, then click .

Patterns

Patterns automatically move the camera according to manually-entered movements.

To add patterns:

1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then click Pan/Tilt/Zoom.
2. The PTZ controls open. Click to open advanced PTZ controls, then click .
3. Click the Pattern tab.
4. Under Pattern, enter the number of the pattern you want to create.
5. Move the camera to the desired starting position, then click Start.
6. Using the on-screen controls, move the camera in any pattern you wish. When finished, click End.

To run a pattern: * Under No., select the number of the pattern you want to go to, then click .

AutoScan

An autoscan automatically cycles between a left and right point.

To configure autoscan:

1. From the Live View display of your PTZ camera, right-click to open the Quick Menu, then click Pan/Tilt/Zoom.
2. The PTZ controls open. Click to open advanced PTZ controls, then click .
3. Click the Border tab.
4. Move the camera into the desired left position and click Left.
5. Move the camera into the desired right position and click Right.

To run autoscan: * Click .

For more information on configuring your PTZ camera, see the following articles:

• Controlling Your 4K Ultra HD IP 25— Pan-Tilt-Zoom Camera
• Using Auto Tracking