This article gives installation instructions for your AJLZ junction box for PTZ cameras.
What's Included:
- Junction Box
- 5 mm Allen Key
- Silicone Plug
- Machine Screws (8)
- Washers (16)
- Expansion Bolts (4)
- Cable Glands (3)
- Cable Ties (5)
Installation:
Warning: Install in an area that can support 3 total weight of the camera and junction box.
- Use the Allen key to loosen the screws and open the junction box.
- Remove the screws with the Allen key to detach the back bracket.
- Optional Customization: Install a converter, air circuit breaker, standard socket, surge protectors, and a power adapter.
Note: The products mentioned and shown above are not included.
- Optional Customization: Use a Phillips head screwdriver to remove any unused trays inside the junction box.
- Drill holes in the wall and install the back bracket with expansion bolts.
- Lower the junction box onto the back bracket.
- Tighten the screws using the Allen key.
- Remove the silicone plug and open it along the slit.
- Insert the cable into the plug and reinstall the plug into the junction box.
- Use the appropriate screws and washers to attach the PTZ camera to the front of the junction box.
- Weatherproof the Wiring: Connect the necessary cables, pass them and the camera cables through the bottom holes, and secure them with cable glands.
- Close the junction box and tighten all four screws.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article