AEX16 Series - 16-Port PoE Switch: Installation Guide

Modified on Thu, Feb 20 at 6:15 AM

This article gives installation instructions for your AEX16 16-Port PoE Switch.

What's Included:

Follow all instructions for safe use and best performance.
Use the switch within given temperature, humidity and voltage levels noted in the switch specifications.
Do not disassemble the switch.
You may need to clean periodically using a cloth. If you need to clean the switch, disconnect it from its power source first. Do not clean the switch with any liquid, harsh, chemical-based cleaners, or damp materials.
Keep the switch away from water and out of damp areas.
Not intended for submersion in water. Installation in a sheltered location recommended.
Do not place the switch on unstable surfaces or underneath heavy objects, and avoid dropping the switch.
Allow for adequate space for ventilation between the device and objects around it.
Ensure that the operating voltage is the same as labeled in the switch

Warning: Install in an area that can support the total weight of the camera and accessories.

Attach the provided rubber feet at each bottom corner of the switch.

Attaching rubber feet

Your switch can be installed on an EIA-19" (48.26 cm) equipment rack.

Install the mounting brackets on each of the switch's side panels using the provided screws.
Use the provided screws to mount the switch to the rack.

Installing your switch on a rack

Setup Diagram